Skip to main content

IPMI, Serial over LAN and Redfish

These services manage the single computer attached to BliKVM. Open Settings → Maintenance → IPMI and Redfish as an administrator on an App version that includes this page. Both services are off by default. The page saves settings automatically.

Power operations use the ATX connection to the computer. Connect the applicable motherboard power, reset and power-state leads before testing those operations.

IPMI power and Serial over LAN​

  1. Enter the IPMI listen address. Use the IP address assigned to BliKVM on the management network. IPMI listens on UDP 623 at that address.
  2. Create an IPMI username and IPMI password. The username accepts 1–16 printable ASCII characters and the password 12–20. Both exclude spaces. Use these credentials in the IPMI client.
  3. Turn on Enable IPMI. If a required field is missing or invalid, the page shows an alert and leaves IPMI off.
  4. From a management computer, run the following command. Replace the address and username. When prompted, enter the IPMI password.
ipmitool -I lanplus -C 17 -H 192.0.2.10 -U YOUR_IPMI_USER -a power status

For Serial over LAN (SoL), connect an adapter matched to the target computer's serial port. In Settings → Maintenance → Serial Settings, select the port and matching baud rate and mark it as connected to the target device. Turn on Enable Serial over LAN after enabling IPMI. The page shows an alert if the target port has not been configured, is unavailable, or belongs to the KVM switch.

ipmitool -I lanplus -C 17 -H 192.0.2.10 -U YOUR_IPMI_USER -a sol activate

Redfish power and local media​

Turn on Enable Redfish and connect over HTTPS to the same address used for the BliKVM web interface. Use a BliKVM account with the required permissions via HTTP Basic authentication. For accounts with two-factor authentication, use a scoped BliKVM API token.

OperationRequestBody or result
Discover the serviceGET /redfish/v1/Service links
Read power stateGET /redfish/v1/Systems/0PowerState
Power onPOST /redfish/v1/Systems/0/Actions/ComputerSystem.Reset{"ResetType":"On"}
Read media stateGET /redfish/v1/Managers/BMC/VirtualMedia/MSDCurrent virtual-media status
Mount a stored imagePOST /redfish/v1/Managers/BMC/VirtualMedia/MSD/Actions/VirtualMedia.InsertMedia{"Image":"rescue.iso"}
Eject the imagePOST /redfish/v1/Managers/BMC/VirtualMedia/MSD/Actions/VirtualMedia.EjectMedia{}

Upload the image to BliKVM first and pass its filename to InsertMedia. Use Virtual Media in the web interface to mount an ISO from a URL.